メインコンテンツにスキップ

はじめに

The hair dryer is an electromechanical device that blows ambient or hot hair over damp hair to speed the evaporation of water to dry the hair. Developed during the early-1920s in Germany. After decades of development, the hair dryer becomes a daily device to dry hair and style.

この分解は修理ガイドでは ありません。 お持ちのModel CVS124Aを修理する際は、iFixitの修理ガイドをご利用ください。

  1. Locate the screw on the handle and remove them with a Phillips screwdriver.
    • Locate the screw on the handle and remove them with a Phillips screwdriver.

    • All of the hair dryer’s components are held together by these two screws. Parts may quickly separate after screw removal.

  2. Remove the top portion of the handle. The model information and warnings are engraved on the top portion.
    • Remove the top portion of the handle.

    • The model information and warnings are engraved on the top portion.

  3. Remove the settings switch by lifting straight up.
    • Remove the settings switch by lifting straight up.

  4. Remove the internal switch from the rear portion of the handle.
    • Remove the internal switch from the rear portion of the handle.

  5. iPhoneのバッテリーキット

    Only $29.99

    Buy Now

    iPhoneのバッテリーキット

    Only $29.99

    Buy Now
  6. Remove the lower portion of the handle by sliding the peg out of the slot at the top of the handle.
    • Remove the lower portion of the handle by sliding the peg out of the slot at the top of the handle.

  7. Handle - ABS injection moulding
    • Handle - ABS injection moulding

  8. Take off the protective jacket outside the wire. Take off the protective jacket outside the wire.
    • Take off the protective jacket outside the wire.

  9. Separate the iron case with the back case by using 6.5mm flathead screwdriver. Take off the fan after separation. Pull on the back of the fan motor to gently lift the motor out of the hair dryer.
    • Separate the iron case with the back case by using 6.5mm flathead screwdriver. Take off the fan after separation.

    • Pull on the back of the fan motor to gently lift the motor out of the hair dryer.

  10. The fan motor The fan motor
    • The fan motor

  11. Separate the back and front case by using the 6.5mm flathead screwdriver.
    • Separate the back and front case by using the 6.5mm flathead screwdriver.

  12. At this point you can pull the complete electronic sub assembly  from the front case. Coils
    • At this point you can pull the complete electronic sub assembly from the front case.

    • Coils

  13. All the parts after the teardown.
    • All the parts after the teardown.

任心怡

メンバー登録日: 2018年10月15日

205 ポイント

1ガイドが承認済み

コメントを追加する

統計データを表示:

過去 24時間: 0

過去 7 日: 2

過去 30 日: 7

今までの合計 250