はじめに

For this teardown you should have a small phillips screwdriver a flathead screwdriver or some other kind of prying device. A 3mm phillips screwdriver will work for all of the screws in this teardown. Note: This teardown does not include removing any components from the internal PCB.

この分解は修理ガイドでは ありません。 お持ちのMicrosoft Wireless Mobile Mouse 4000を修理する際は、iFixitの修理ガイドをご利用ください。

Undo the bottom battery clip and remove any AA battery within.
  • Undo the bottom battery clip and remove any AA battery within.

  • Remove the USB receiver if stored

  • The device should look as pictured.

コメントを追加する

Using your prying device, pick at the corner of the lower rubber traction pad on the bottom of the device.
  • Using your prying device, pick at the corner of the lower rubber traction pad on the bottom of the device.

  • Pull this traction pad off to reveal the screw underneath.

  • Unscrew this middle screw using the small 3mm phillips screwdriver.

  • Carefully disconnect the top click pads.

    • Note: Moving each towards its corresponding outer edge makes this easier

コメントを追加する

  • Unscrew the two screws on the top front of the device.

  • Using prying tool undo the back clip piece shown.

コメントを追加する

  • Remove two screws in the top back of the mouse.

  • Pry the top and bottom halves apart.

    • This takes a little prying between the outer pieces, which are connected to the top half, and the plastic bottom half.

  • The mouse should now have two separate parts as shown.

コメントを追加する

  • Using prying tool press against the bottom of each side of the click wheel apparatus to cause it to snap out of place.

    • The end of the click wheel closest to the middle of the mouse is more difficult to remove and requires getting the prying tool down the gap to reach the spot where it is clipped in.

コメントを追加する

  • Remove 2 Screws from either side of the click wheel on the lower tier of the PCB.

  • Remove the 3 screws from the top tier of the PCB.

  • Do not separate the PCB from the plastic backing too fast. There is a separate small PCB screwed into the plastic backing which is connected to the main PCB with 2 wires.

  • Remove the screw holding the small PCB to the plastic backing

コメントを追加する

  • Parts of the PCB are listed below and correspond to the colored circles on the pictures

    • LED tracking apparatus

    • Battery power receiving mechanism

    • Left and Right Click Buttons

    • Click Wheel Button

    • Scroll wheel sensing apparatus

    • Programmable Button

コメントを追加する

Austin Fox

メンバー登録日: 2012年04月10日

81 ポイント

1ガイドが承認済み

Thank you for this guide. It helped me successfully repair my mouse!

Justin Hren - 返信

nice post!

thumb up for u!

Wilson Chan - 返信

great, thanks for do it!

antonio sanchez - 返信

Thanks a lot, I was able to replace the mouse wheel !

Niek - 返信

コメントを追加する

統計データを表示:

過去 24時間: 7

過去 7 日: 55

過去 30 日: 216

今までの合計 10,954