はじめに

Tearing down a Cyclops Helios headlamp. Both hardware identification and functionality for the device are discussed.

この分解は修理ガイドでは ありません。 お持ちのCyclops Heliosを修理する際は、iFixitの修理ガイドをご利用ください。

Power off Cyclops Helios before tearing down by pushing the black button until the LEDs no longer emit visible light.
  • Power off Cyclops Helios before tearing down by pushing the black button until the LEDs no longer emit visible light.

    • Black button - circled in red

コメントを追加する

Using two hands, carefully separate the front panel and back panel of the Cyclops Helios. Front panel - boxed in red Back panel - boxed in blue
  • Using two hands, carefully separate the front panel and back panel of the Cyclops Helios.

  • Front panel - boxed in red

  • Back panel - boxed in blue

コメントを追加する

Use a Phillips head screwdriver to remove two screws from the front panel. The two screws fasten the outer enclosure with the inner electronics of the front panel.
  • Use a Phillips head screwdriver to remove two screws from the front panel.

    • The two screws fasten the outer enclosure with the inner electronics of the front panel.

コメントを追加する

Within the enclosure of the front panel there is a clear plastic lens, and plastic button insert. Both are removable. Clear plastic lens - boxed in red Plastic button insert - circled in blue
  • Within the enclosure of the front panel there is a clear plastic lens, and plastic button insert. Both are removable.

    • Clear plastic lens - boxed in red

    • Plastic button insert - circled in blue

コメントを追加する

The inner electronics of module of the front panel includes a parabolic mirror, circuit board, and battery holder. Circuit board - boxed in blue Parabolic mirror - boxed in red
  • The inner electronics of module of the front panel includes a parabolic mirror, circuit board, and battery holder.

    • Circuit board - boxed in blue

    • Parabolic mirror - boxed in red

    • Battery holder - boxed in green

コメントを追加する

Separate the circuit board from the battery holder by desoldering the black and red wires from the battery holder. Separate the circuit board from the battery holder by desoldering the black and red wires from the battery holder.
  • Separate the circuit board from the battery holder by desoldering the black and red wires from the battery holder.

コメントを追加する

Shaun Koide

メンバー登録日: 2013年11月14日

161 ポイント

1ガイドが承認済み

コメントを追加する

統計データを表示:

過去 24時間: 0

過去 7 日: 1

過去 30 日: 3

今までの合計 609