Skip to main content

ガイド紹介

This guide goes through each step required to disassemble an Afterglow Prismatic Wired Controller for the Xbox One.

この分解は修理ガイドでは ありません。 お持ちのAfterglow Prismatic Wired Controller for Xbox Oneを修理する際は、iFixitの修理ガイドをご利用ください。

  1. Use a Phillips #0 Screwdriver to remove the seven Phillips head screws. Separate two halves of clear casing by holding one side and lifting the other.
    • Use a Phillips #0 Screwdriver to remove the seven Phillips head screws.

    • Separate two halves of clear casing by holding one side and lifting the other.

  2. Use a Phillips #0 Screwdriver to remove the seven Phillips head screws. Lift motors off of controller. Lift circuit board off of controller.
    • Use a Phillips #0 Screwdriver to remove the seven Phillips head screws.

    • Lift motors off of controller.

    • Lift circuit board off of controller.

  3. Android 修理キット

    交換用スクリーンやバッテリーの修理キット

    ショップを見る

    Android 修理キット

    交換用スクリーンやバッテリーの修理キット

    ショップを見る
  4. Use a Phillips #0 Screwdriver to remove the three screws. Remove triggers by lifting them off the circuit board. Lift the circuit board off of the controller.
    • Use a Phillips #0 Screwdriver to remove the three screws.

    • Remove triggers by lifting them off the circuit board.

    • Lift the circuit board off of the controller.

  5. Remove the power and mute button by pulling them out. They will be loose at this point and may fall out by themselves. Remove the power and mute button by pulling them out. They will be loose at this point and may fall out by themselves. Remove the power and mute button by pulling them out. They will be loose at this point and may fall out by themselves.
    • Remove the power and mute button by pulling them out. They will be loose at this point and may fall out by themselves.

Zachary Crandall

メンバー登録日: 2014年01月14日

141 Reputation

1ガイドが承認済み

チーム

Cal Poly, Team 17-5, Forte Winter 2014 Cal Poly, Team 17-5, Forte Winter 2014人のメンバー

CPSU-FORTE-W14S17G5

5 メンバー

6のガイドは作成済み

4 Comments

how u clean it because i accident spill tea inside i cleaned it once it worked for a weak and it started to do it again how can i fix it please help me

Xavier Adams - 返信

a phillips #0 doesnt seem to fit into the screws.

reagen_lionel - 返信

How are the poitve and negative leads soldered to the board as I would like to swap wireless internals into controller and keep the lights

glohoodlum - 返信

I am curious about the pair of programmable wheels on the underside, do they have any markings or part numbers on them that would help in sourcing replacements? I’ve been in touch with PDP and confirmed that my controller is past their warranty period, but it is only the underside wheels that have failed and I’m trying to find replacements.

S.R. Cooper - 返信

Add Comment

View Statistics:

Past 24 Hours: 15

Past 7 Days: 63

Past 30 Days: 309

All Time: 13,121