キャンセル
この製品はお住まいの国ではお買い求めできません。
アイテムコード: IF308-018-1
この製品はお住まいの国ではお買い求めできません。
$6.99
iFixit Pro の割引が適用されました。登録番号:
$6.99
A-在庫の中古パーツは良好な状態です。
B-在庫のパーツは表面上の磨耗が多少あります。
C-在庫のパーツは表面上の磨耗がありますが、機能上問題はありません。
$6.99
iFixit Pro の割引が適用されました。登録番号:
$6.99
在庫切れ
発送準備をする
在庫切れ
発送準備をする
在庫数が少なくなっています。
製品詳細
概要
概要
Once you're in and out of the Apple Watch and it's time to seal everything back up, use this adhesive strip to ensure a tight seal between the case and the display.
This replacement adhesive strip fits the 42 mm case Apple Watch Original model and Series 1, and 2 models.
以下はパーツの組み立て一覧です。
以下はパーツの組み立て一覧です。
互換性
Apple Watch
|
|
|
Apple Watch Series 1
|
|
|
Apple Watch Series 2
|
|
修理にまつわるストーリー
Replaced broken screen
After pulling screen off and cleaning it all as instructed with a little bit of alcohol I thought I was doing well. So then I continued with the repair by placing the adhesive on he watch under the force touch, placed the force touch sensor on top of adhesive. Continued by putting second adhesive on top of the force touch sensor and connect cables and pressed screen back into place firmly. I even placed in a firmly tightened clamp overnight to ensure I tight fit. Worked great for half the day and noticed the screen lifting. Now I have no recourse but to try again as it won’t stay down. I even tried to warm the adhesive up with some low heat in hopes to no avail.
Don’t break your screen in the first place.
Replaced broken screen
After pulling screen off and cleaning it all as instructed with a little bit of alcohol I thought I was doing well. So then I continued with the repair by placing the adhesive on he watch under the force touch, placed the force touch sensor on top of adhesive. Continued by putt . . .
