メインコンテンツにスキップ
英語
日本語

手順 11を翻訳中

手順11
Continue removing the circuit board's screws. On both sides place two fingers between the circuit board and the face of the radio. Gently pull the circuit board straight back being careful not to break the volume and tuning knob posts on the opposite side of the board.
  • Continue removing the circuit board's screws.

  • On both sides place two fingers between the circuit board and the face of the radio.

  • Gently pull the circuit board straight back being careful not to break the volume and tuning knob posts on the opposite side of the board.

  • The two white cables are soldered to the circuit board and the power transformer at the back of the radio. Once removed, the circuit board has to be set aside inside the radio.

ここに翻訳を挿入する

ここに翻訳を挿入する

ここに翻訳を挿入する

ここに翻訳を挿入する

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります