手順番号4–LG G6 Rear Glass Panel Removalを翻訳 - iFixit

修理を始めるには

修理する権利

ストア

注意：あなたはさきほど閲覧しているガイドの前提となるページを編集しています。あなたが行った変更は、この手順を含むガイド全体に影響を与えます。

ガイドに戻る

英語

日本語

前の手順次の手順

手順 4を翻訳中

手順4

To make this step easier, you can prop up the heated edge of the phone on something that is about 0.5 inches (13 mm) thick, like an eraser. This will angle the phone so that the opening tool is easier to insert.

If you don't have a small object for propping, you can (carefully) perform this step at the edge of a desk or table to achieve the same angle of entry.

Lift the rear panel's bottom edge with your suction cup, opening a slight gap between the panel and the frame.

To make this step easier, you can prop up the heated edge of the phone on something that is about 0.5 inches (13 mm) thick, like an eraser. This will angle the phone so that the opening tool is easier to insert.
If you don't have a small object for propping, you can (carefully) perform this step at the edge of a desk or table to achieve the same angle of entry.
Lift the rear panel's bottom edge with your suction cup, opening a slight gap between the panel and the frame.
This may require a significant amount of force. If you have trouble, apply more heat to further soften the adhesive, and try again. The adhesive cools very fast, so you may need to heat it repeatedly.
Once you've created a gap, press the flat end of an opening tool into the gap.
The rear glass panel is fragile and can break if you use too much force or attempt to pry with metal tools.

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります。