メインコンテンツにスキップ

注意:あなたは必要条件ガイドを編集しています。あなたが行なう変更は、この手順を含む全ての2個のガイドに反映されます。

英語
日本語

手順 5を翻訳中

手順5
Once all of the adhesive is freed from under the logic board/battery assembly, lift the assembly up from the side and carefully rotate it over to access the underside of the battery. The logic board is still attached to the rear case. Do not try to completely separate the assembly, or you will rip this ribbon cable. The logic board is still attached to the rear case. Do not try to completely separate the assembly, or you will rip this ribbon cable.
  • Once all of the adhesive is freed from under the logic board/battery assembly, lift the assembly up from the side and carefully rotate it over to access the underside of the battery.

  • The logic board is still attached to the rear case. Do not try to completely separate the assembly, or you will rip this ribbon cable.

ここに翻訳を挿入する

ここに翻訳を挿入する

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります