Skip to main content
英語
日本語

手順 7を翻訳中

手順7
The back of the display assembly is held to the metal frame with four screws that must be removed. Carefully rotate the hinges upward just enough to allow the removal of the four screws on the sides of the display frame. Be careful of the cable for the magnetic lid close sensor. You may need to temporarily unstick the sensor from the frame or pull on the cable a bit to make it extend far enough.
Lid
  • The back of the display assembly is held to the metal frame with four screws that must be removed.

  • Carefully rotate the hinges upward just enough to allow the removal of the four screws on the sides of the display frame.

  • Be careful of the cable for the magnetic lid close sensor. You may need to temporarily unstick the sensor from the frame or pull on the cable a bit to make it extend far enough.

  • Four 6mm Phillips screws.

  • Four 3mm Phillips screws.

ここに翻訳を挿入する

ここに翻訳を挿入する

ここに翻訳を挿入する

ここに翻訳を挿入する

ここに翻訳を挿入する

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります