メインコンテンツにスキップ
英語
日本語

手順 5を翻訳中

手順5
You need to wire them in Parallel (i.e. 1s3p pack). Two unprotect will be wired to the JBL BMS board. I solder the black wire to the B+ and the red wire to the B-. To keep the next replacement easier, I only connect the battery by twisting the color coded wires together and wrapping them with electrical tape.
Replacing the battery (OPTION B)
  • You need to wire them in Parallel (i.e. 1s3p pack).

  • Two unprotect will be wired to the JBL BMS board. I solder the black wire to the B+ and the red wire to the B-.

  • To keep the next replacement easier, I only connect the battery by twisting the color coded wires together and wrapping them with electrical tape.

  • One unprotected cell will be in the original battery compartment inside the cell holder (as shown) connect to one side of the BMS board.

  • Two cells will be inside the speaker compartment behind the Bass Radiator. The unprotected one (right hand side radiator) will connect directly to the BMS board.

  • The protected one (after I open and rearrange the PCB of the battery for a better fit into the speaker compartment) will connect parallel to the protected one from other side of the bass radiator.

ここに翻訳を挿入する

ここに翻訳を挿入する

ここに翻訳を挿入する

ここに翻訳を挿入する

ここに翻訳を挿入する

ここに翻訳を挿入する

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります