メインコンテンツにスキップ

注意:あなたは必要条件ガイドを編集しています。あなたが行なう変更は、この手順を含む全ての41個のガイドに反映されます。

英語
中国語

手順 1を翻訳中

手順1
If your I/O Board cable's connectors have notches in the padding, you will need to release a locking lever underneath the notch in order to remove the cable. If this is the case, don't pry up on the connector until the levers are unlatched. Using the flat end of a spudger, pry the I/O Board connector straight up out of its socket on the logic board. During reassembly, connect this end first as it does not flex.
  • If your I/O Board cable's connectors have notches in the padding, you will need to release a locking lever underneath the notch in order to remove the cable. If this is the case, don't pry up on the connector until the levers are unlatched.

  • Using the flat end of a spudger, pry the I/O Board connector straight up out of its socket on the logic board.

  • During reassembly, connect this end first as it does not flex.

  • In a similar fashion, remove the I/O Board connector from its socket on the I/O Board.

  • Remove the I/O Board cable from the MacBook Pro.

如果 I/O 板电缆的连接器在衬垫中有槽口,你需要松开槽口下方的锁定杆以移除电缆。 如果是这种情况,请在拉杆解锁之前不要撬起接口。

使用撬棒扁平的一端,将 I/O 板连接器从主板上的插座中直接撬出。

在重新组装设备的时候,首先连接这一端,因为它不会弯曲。

以类似的方式,从 I/O 板上的插槽中卸下 I/O 板连接器。

从 MacBook Pro 上拔下 I/O 板电缆。

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります