メインコンテンツにスキップ

修理を始めるには

修理する権利

ストア

注意:あなたは必要条件ガイドを編集しています。あなたが行なう変更は、この手順を含む全ての36個のガイドに反映されます。

英語
イタリア語

手順 3を翻訳中

手順3
Use the tip of a spudger to flip up the retaining flap on the left fan ribbon cable ZIF socket. Be sure you are prying up on the hinged retaining flap, not the socket itself. Starting at the top of the cable, slide a plastic opening tool under the left fan cable to free it from the logic board.
  • Use the tip of a spudger to flip up the retaining flap on the left fan ribbon cable ZIF socket.

  • Be sure you are prying up on the hinged retaining flap, not the socket itself.

  • Starting at the top of the cable, slide a plastic opening tool under the left fan cable to free it from the logic board.

  • Use caution when freeing the cable, as it is strongly adhered to the logic board. If necessary, use an iOpener or hair dryer to heat the cable in order to soften the adhesive and make it easier to remove.

  • Lift the left fan out of the device.

  • When reinstalling the fan, it's easiest connect the fan ribbon cable as you drop the fan in place, rather than after you've installed the three fan screws.

Usa la punta di uno spudger per far scattare la linguetta di bloccaggio sullo zoccolo ZIF del cavo piatto della ventola sinistra.

Poni attenzione a far leva sulla linguetta di bloccaggio incernierata e non sullo zoccolo stesso.

Iniziando dalla cima del cavo, fai scorrere un attrezzo di apertura in plastica sotto il cavo della ventola destra per liberarlo dalla scheda logica.

Fai attenzione quando liberi il cavo, perché aderisce fortemente alla scheda logica. Se necessario, usa un iOpener o un asciugacapelli per riscaldare il cavo allo scopo di ammorbidire l'adesivo e rendere più facile la rimozione del cavo stesso.

Solleva dal dispositivo la ventola sinistra.

[* black] Use the tip of a spudger to flip up the retaining flap on the left fan ribbon cable ZIF socket.
[* icon_caution] Be sure you are prying up on the hinged retaining flap, '''not''' the socket itself.
[* black] Starting at the top of the cable, slide a plastic opening tool under the left fan cable to free it from the logic board.
[* icon_caution] Use caution when freeing the cable, as it is strongly adhered to the logic board. If necessary, use an iOpener or hair dryer to heat the cable in order to soften the adhesive and make it easier to remove.
[* black] Lift the left fan out of the device.
[* icon_reminder] When reinstalling the fan, it's easiest connect the fan ribbon cable as you drop the fan in place, rather than after you've installed the three fan screws.

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります