手順 7を翻訳中
手順7


PCB and Camera Module
-
The only thing holding the camera to the board at this point is another flexible printed circuit cable with some adhesive on the connector and hold down.
-
This time I started from the connector end and carefully but with pressure used my 1.0 flathead bit to cleanly scrape off the goo.
-
Flip up the connector hold down "latch" with a spudger or the flathead bit and remove the flex cable and pull the camera module out.
クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります。