メインコンテンツにスキップ

修理を始めるには

修理する権利

ストア

英語
日本語

手順 2を翻訳中

手順2
When desoldering and removing the OEM LEDs, make sure to leave one soldered in place to use as a height reference. I replaced the "Low" LED first. It's the only one on the PCB that doesn't have a surface mount capacitor.
Desolder/Resolder LEDs
  • When desoldering and removing the OEM LEDs, make sure to leave one soldered in place to use as a height reference.

  • I replaced the "Low" LED first. It's the only one on the PCB that doesn't have a surface mount capacitor.

  • When removing the "High" and "Medium" LEDs be careful not to loose the capacitor. These are highlighted in red. It is possible to do this without removing it from the PCB as shown in Photo 2. Just reapply solder if needed.

  • Repeat until all 3, or the desired number, of LEDs are replaced.

ここに翻訳を挿入する

ここに翻訳を挿入する

ここに翻訳を挿入する

ここに翻訳を挿入する

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります