メインコンテンツにスキップ

修理を始めるには

修理する権利

ストア

ご注意:あなたは前提となるガイドを編集しています。あなたが行なう変更は、この手順を含むガイド全体に反映されます。

英語
日本語

手順 5を翻訳中

手順5
Gently lift up on the top in order to separate it from the half that it is attached to.
Remove Upper Electronics
  • Gently lift up on the top in order to separate it from the half that it is attached to.

  • Be gentle when lifting the top as there are cables soldered into place that run down the length of the device. Don't jerk it out, NO PUN INTENDED, as you may damage these wires or their solder points.

  • Pull the plastic piece out from its retaining slot.

  • At this point, the PCB may make a slight popping sound. It didn't break! It simply popped out of it's retaining slot as well as you removed the plastic piece.

  • Remember, be gentle with the grey plastic piece. It's still attached to the bottom electronics via the 2 static cords. DO NOT over stretch these cords.

  • Remove the single screw that's hidden underneath the top/power button unit.

ここに翻訳を挿入する

ここに翻訳を挿入する

ここに翻訳を挿入する

ここに翻訳を挿入する

ここに翻訳を挿入する

ここに翻訳を挿入する

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります