メインコンテンツにスキップ

修理を始めるには

修理する権利

パーツ&ツール

英語
日本語

手順 9を翻訳中

手順9
The clutch actuator is held in place with a  threaded ring. Ideally, you would use a C-spanner to remove it, but access is so restricted that you will probably need to use a drift and hammer... Watch out for the 3/8" ball under the clutch actuator. Now you can undo the nut on the end of the mainshaft.
Remove the clutch actuator and mainshaft
  • The clutch actuator is held in place with a threaded ring. Ideally, you would use a C-spanner to remove it, but access is so restricted that you will probably need to use a drift and hammer...

  • Watch out for the 3/8" ball under the clutch actuator.

  • Now you can undo the nut on the end of the mainshaft.

  • The nut on the end of the mainshaft may be extremely tight. Clamp the mainshaft firmly in a soft-jawed vice and use a power bar to undo it.

  • There should be a pin or screw to align the clutch actuator. You will need to remove it before you can get the mainshaft bearing out. If a screw has been used instead of a pin, an impact screwdriver might help to get it out.

  • Now you can drive out the mainshaft bearing. It is worth replacing this bearing as a matter of course as it is relatively cheap.

ここに翻訳を挿入する

ここに翻訳を挿入する

ここに翻訳を挿入する

ここに翻訳を挿入する

ここに翻訳を挿入する

ここに翻訳を挿入する

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります