メインコンテンツにスキップ

修理を始めるには

修理する権利

ストア

英語
日本語

手順 7を翻訳中

手順7
Tap the blanking plug home with a little Loctite 603 to hold it in place. If your casing has a hole next to the layshaft bush, an M3x19mm screw appears to fit perfectly. Use some Loctite 603 to hold it in place. Ensure the other end of the retaining screw is recessed at least 1mm from the layshaft bush surface.
Fit the blanking plug and oil seal
  • Tap the blanking plug home with a little Loctite 603 to hold it in place.

  • If your casing has a hole next to the layshaft bush, an M3x19mm screw appears to fit perfectly. Use some Loctite 603 to hold it in place.

  • Ensure the other end of the retaining screw is recessed at least 1mm from the layshaft bush surface.

  • Fit the metal spacer (larger diameter inwards) into the oil seal (metal side outwards) and tap the seal into the casing. When fully home, it should sit ~4mm in from the outer surface i.e. do not leave it flush, otherwise it will bind on the sprocket.

  • The output seal (041267) is the same as the one used on AMC Villiers 2-stroke gearboxes. Size is 1.81" x .131 x .21"

  • At this point, it is a good idea to test fit the sleeve gear and outer sprocket to check that everything turns smoothly.

  • If the sprocket binds against the seal, make sure the seal is fully home.

ここに翻訳を挿入する

ここに翻訳を挿入する

ここに翻訳を挿入する

ここに翻訳を挿入する

ここに翻訳を挿入する

ここに翻訳を挿入する

ここに翻訳を挿入する

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります