メインコンテンツにスキップ
英語
日本語

手順 3を翻訳中

手順3
Use a spudger to disconnect ribbon cable(s) 1, 2, and 3. Just a reminder. The 3rd cable is actually connected to the board by a port, which requires an inset connector. Lift up the black tab on the back of the inset connector port, and then the 3rd ribbon should slide right out.
  • Use a spudger to disconnect ribbon cable(s) 1, 2, and 3.

  • Just a reminder. The 3rd cable is actually connected to the board by a port, which requires an inset connector.

  • Lift up the black tab on the back of the inset connector port, and then the 3rd ribbon should slide right out.

ここに翻訳を挿入する

ここに翻訳を挿入する

ここに翻訳を挿入する

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります