メインコンテンツにスキップ

注意:あなたはさきほど閲覧しているガイドの前提となるページを編集しています。あなたが行った変更は、この手順を含むガイド全体に影響を与えます。

英語
日本語

手順 4を翻訳中

手順4
Remove the single 2.3 mm Phillips screw securing the battery connector to the logic board. To reduce the risk of a short, you can insert a battery blocker or a modified opening pick to disconnect the battery. Slide the battery blocker underneath the battery connector area of the logic board, and leave it in place while you work.
  • Remove the single 2.3 mm Phillips screw securing the battery connector to the logic board.

  • To reduce the risk of a short, you can insert a battery blocker or a modified opening pick to disconnect the battery.

  • Slide the battery blocker underneath the battery connector area of the logic board, and leave it in place while you work.

ロジックボードにバッテリーコネクターを留めている2.3 mm#000 プラスネジを1本外します。

バッテリーコネクターの下に開封ピックを差し込んで、ロジックボードから接続を外します。

[* red] Remove the single 2.3 mm Phillips #000 screw securing the battery connector to the logic board.
[* black] Inserticon_note] To reduce the risk of a battery isolationshort, you can insert a [product|IF145-304-2|battery blocker|new_window=true] or a modified opening pick to disconnect the battery.
[* black] Slide the battery blocker
underneath the battery connector to disconnect it fromarea of the logic boardboard, and leave it in place while you work.
[* red] Remove the single 2.3 mm Phillips #000 screw securing the battery connector to the logic board.
[* black] Inserticon_note] To reduce the risk of a battery isolationshort, you can insert a [product|IF145-304-2|battery blocker|new_window=true] or a modified opening pick to disconnect the battery.
[* black] Slide the battery blocker
underneath the battery connector to disconnect it fromarea of the logic boardboard, and leave it in place while you work.

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります