メインコンテンツにスキップ

注意:あなたはさきほど閲覧していたガイドの前提条件を編集しています。あなたが行った変更は、この手順を含む個のガイド全体に影響を与えます。

英語
日本語

手順 3を翻訳中

手順3
While depressing the connector lock, use a heavy duty spudger to pry the power supply connector away from its socket on the logic board. It will be necessary to work from alternate sides until the connector is free. Your power supply may have an ambient light sensor cable attached from the power supply to the logic board. If so, carefully use a spudger to push out the cable towards you using the sides of the cable alternatively to help you slide it out.
  • While depressing the connector lock, use a heavy duty spudger to pry the power supply connector away from its socket on the logic board.

  • It will be necessary to work from alternate sides until the connector is free.

  • Your power supply may have an ambient light sensor cable attached from the power supply to the logic board. If so, carefully use a spudger to push out the cable towards you using the sides of the cable alternatively to help you slide it out.

ここに翻訳を挿入する

ここに翻訳を挿入する

ここに翻訳を挿入する

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります