メインコンテンツにスキップ

注意:あなたはさきほど閲覧しているガイドの前提となるページを編集しています。あなたが行った変更は、この手順を含むガイド全体に影響を与えます。

英語
日本語

手順 2を翻訳中

手順2
There are two adhesive strips in the center of the phone connecting the rear case to the battery, you'll need to remove them to open the phone. When the edges of the cover are free from adhesive, tilt it to allow access to the battery tabs.
  • There are two adhesive strips in the center of the phone connecting the rear case to the battery, you'll need to remove them to open the phone.

  • When the edges of the cover are free from adhesive, tilt it to allow access to the battery tabs.

  • Use tweezers to pull the two black adhesive strips out of the phone but don't pull just yet.

周辺の接着剤を緩めた後、吸引ハンドルでバックカバーを引き上げます。

ピンセットを使用して、バッテリーの2本の接着剤に取り付けられた2本の黒いストラップを引き出します。

[* black] After theicon_note] There are two adhesive aroundstrips in the egdes is loosened, pull upcenter of the phone connecting the rear case to the battery, you'll need to remove them to open the phone.
[* black] When the edges of
the back cover with your suction handleare free from adhesive, tilt it to allow access to the battery tabs.
[* black] Use a tweezertweezers to pull outthe two black straps that are attached to two pieces of adhesive right onstrips out of the batteryphone but don't pull just yet.
[* black] After theicon_note] There are two adhesive aroundstrips in the egdes is loosened, pull upcenter of the phone connecting the rear case to the battery, you'll need to remove them to open the phone.
[* black] When the edges of
the back cover with your suction handleare free from adhesive, tilt it to allow access to the battery tabs.
[* black] Use a tweezertweezers to pull outthe two black straps that are attached to two pieces of adhesive right onstrips out of the batteryphone but don't pull just yet.

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります