メインコンテンツにスキップ

修理を始めるには

修理する権利

パーツ&ツール

注意:あなたは必要条件ガイドを編集しています。あなたが行なう変更は、この手順を含む全ての9個のガイドに反映されます。

英語
日本語

手順 2を翻訳中

手順2
Avoid to lift only the display instead of the whole phone assembly as doing so may cause damage to the screen. Use an iSclack or a suction handle to separate the phone assembly from the rear panel.
  • Avoid to lift only the display instead of the whole phone assembly as doing so may cause damage to the screen.

  • Use an iSclack or a suction handle to separate the phone assembly from the rear panel.

  • In case you can‘t manage to lift the phone assembly out of the rear panel you can insert the pointed end of a spudger in the headphone jack opening and press the phone assembly upwards until you create a gap between assembly and rear panel. Then use the spudger to lever the phone assembly out of the panel.

  • Don't remove the rear panel completely yet. There is a cable connected to it! It is running from the finger print sensor to the display unit.

iSclackや吸盤ハンドルを使って、リアパネルからディスプレイユニットを引き離します。

まだリアパネルを完全に取り外さないでください。ケーブルが接続されています!ケーブルは、ディスプレイユニットに指紋センサーをつなげています。

[* icon_caution] Avoid to lift only the display instead of the whole phone assembly as doing so may cause damage to the screen.
[*
black] Use an iSclack or a suction handle to separate the display unitphone assembly from the rear panel.
[* icon_note] In case you can‘t manage to lift the phone assembly out of the rear panel you can insert the pointed end of a spudger in the headphone jack opening and press the phone assembly upwards until you create a gap between assembly and rear panel. Then use the spudger to lever the phone assembly out of the
panel.
[* icon_caution] Avoid to lift only the display instead of the whole phone assembly as doing so may cause damage to the screen.
[*
black] Use an iSclack or a suction handle to separate the display unitphone assembly from the rear panel.
[* icon_note] In case you can‘t manage to lift the phone assembly out of the rear panel you can insert the pointed end of a spudger in the headphone jack opening and press the phone assembly upwards until you create a gap between assembly and rear panel. Then use the spudger to lever the phone assembly out of the
panel.
[* icon_caution] Don't remove the rear panel completely yet. There is a cable connected to it! It is running from the finger print sensor to the display unit.

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります