注意:あなたはさきほど閲覧しているガイドの前提となるページを編集しています。あなたが行った変更は、この手順を含むガイド全体に影響を与えます。
手順 2を翻訳中
手順2

-
Use an iSclack or a suction handle to separate the phone assembly from the rear panel.
[* icon_caution] Avoid to lift only the display instead of the whole phone assembly as doing so may cause damage to the screen. [* black] Use an iSclack or a suction handle to separate the [* icon_note] In case you can‘t manage to lift the phone assembly out of the rear panel you can insert the pointed end of a spudger in the headphone jack opening and press the phone assembly upwards until you create a gap between assembly and rear panel. Then use the spudger to lever the phone assembly out of the panel. |
[* icon_caution] Avoid to lift only the display instead of the whole phone assembly as doing so may cause damage to the screen. [* black] Use an iSclack or a suction handle to separate the [* icon_note] In case you can‘t manage to lift the phone assembly out of the rear panel you can insert the pointed end of a spudger in the headphone jack opening and press the phone assembly upwards until you create a gap between assembly and rear panel. Then use the spudger to lever the phone assembly out of the panel. |
[* icon_caution] Don't remove the rear panel completely yet. There is a cable connected to it! It is running from the finger print sensor to the display unit. |
クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります。