メインコンテンツにスキップ

注意:あなたは必要条件ガイドを編集しています。あなたが行なう変更は、この手順を含む全ての14個のガイドに反映されます。

英語
中国語

手順 7を翻訳中

手順7
Remove the following screws securing the logic board to the case:
  • Remove the following screws securing the logic board to the case:

  • One 2.5 mm Phillips screw near the vibrator motor

  • One 2.4 mm Phillips screw

  • One 3.6 mm standoff along the side of the logic board nearest the battery opening.

  • Use a standoff driver bit and driver handle to remove the single 3.6 mm standoff screw.

  • In a pinch, a small flathead screwdriver will do the job—but use extra caution to ensure it doesn't slip and damage surrounding components.

卸下下列将逻辑板与后壳固定的螺丝。

一个位于振动模块的2.5 mm Phillips 螺丝

一个 2.4 mm Phillips螺丝

一个3.6 mm螺丝在逻辑板右侧最接近电池开口位置。

使用专用螺丝刀或者小型平头起子来卸下单个的3.6mm隔离柱。

[* black] Remove the following screws securing the logic board to the case:
[* red] One 2.5 mm Phillips screw near the vibrator motor
[* orange] One 2.4 mm Phillips screw
[* yellow] One 3.6 mm standoff along the side of the logic board nearest the battery opening.
-[* icon_note] Use a [product|IF145-343|standoff driver bit|new_window=true] or a small flathead screwdriver to remove the single 3.6 mm standoff screw.
+[* icon_note] Use a [product|IF145-343|standoff driver bit|new_window=true] and [product|IF145-326|driver handle|new_window=true] to remove the single 3.6 mm standoff screw.
+[* icon_caution] In a pinch, a small flathead screwdriver will do the job—but use extra caution to ensure it doesn't slip and damage surrounding components.

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります