メインコンテンツにスキップ

更换iPhone 7 Plus的显示屏总成

注意:あなたは必要条件ガイドを編集しています。あなたが行なう変更は、この手順を含む全ての15個のガイドに反映されます。

手順 1を翻訳中

英語
中国語
手順1
iPhone 7 Plus Display Assembly Replacement: 手順 0、 3の画像 1 iPhone 7 Plus Display Assembly Replacement: 手順 0、 3の画像 2 iPhone 7 Plus Display Assembly Replacement: 手順 0、 3の画像 3
  • Make sure the battery is disconnected before you disconnect or reconnect the cables in this step.

  • Use the flat end of a spudger or a fingernail to disconnect the two lower display connectors by prying them straight up from their sockets on the logic board.

  • To re-attach press connectors, press down on one end until it clicks into place, then repeat on the other end. Do not press down on the middle. If the connector is even slightly misaligned, the connector can bend, causing permanent damage.

  • If you have a blank screen, white lines on the display, or partial or complete lack of touch response after reassembling your phone, try disconnecting and carefully reconnecting both of these cables and make sure they are fully seated.

确保电池接口是断开的。

使用撬棒的平端或者指甲以撬开两个下部显示连接器,笔直地从逻辑版的插座上撬起。

若要重新安装连接器,向下按压直到其到位,接着重复按下另一端。请不要按压中部。若连接器未对准,可能会弯曲从而造成永久损伤。

如果你在重新组装手机时有空白屏幕,显示屏上有白线,或部分、完全没有触摸响应,请尝试断开连接并小心地重新连接这两根电缆,并确保它们完全就位。

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります