メインコンテンツにスキップ
英語
日本語

手順 10を翻訳中

手順10
Use needle nose pliers to bend just the tips (approximately 2 mm) of the pins 90° up so that they are pointing the same direction as the IC face. If you bend too much of the pins, they will not be able to reach their assigned holes.
  • Use needle nose pliers to bend just the tips (approximately 2 mm) of the pins 90° up so that they are pointing the same direction as the IC face.

  • If you bend too much of the pins, they will not be able to reach their assigned holes.

ここに翻訳を挿入する

ここに翻訳を挿入する

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります