メインコンテンツにスキップ
英語
日本語

手順 1を翻訳中

手順1
The EM10 charging filter is located next to the power connector on the motherboard.
  • The EM10 charging filter is located next to the power connector on the motherboard.

  • If the filter is missing or obviously broken, move on to STEP 18

  • Use a multimeter to test the EM10 filter - measure the resistance between each of the yellow solder pads, and then between each of the cyan solder pads. If everything is OK you should have close to 0 Ohms between each set of pads. You should NOT have any connection between the cyan pads and yellow pads. If the filter fails either test it needs to be replaced.

ここに翻訳を挿入する

ここに翻訳を挿入する

ここに翻訳を挿入する

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります