メインコンテンツにスキップ
英語
日本語

手順 4を翻訳中

手順4
There are two clips holding the circuit board in.  Using a flat surfaced tool pry on one clip until the circuit board pops up and then you can pull board out. The charging device is soldered to the board so be aware and careful not to break the solder or wire to device.
Removing Circuit Board
  • There are two clips holding the circuit board in. Using a flat surfaced tool pry on one clip until the circuit board pops up and then you can pull board out.

  • The charging device is soldered to the board so be aware and careful not to break the solder or wire to device.

ここに翻訳を挿入する

ここに翻訳を挿入する

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります