注意:あなたはさきほど閲覧しているガイドの前提となるページを編集しています。あなたが行った変更は、この手順を含むガイド全体に影響を与えます。
-
Remove the three 3 mm T10 screws securing the hard drive to the Xbox.
-
There is one screw on the rear left side of the hard drive that is only visible when the IDE ribbon cable is lifted up. The other two are at the front right and left sides of the hard drive.
-
The screw on the lower left corner of the disk drive is not in the hole that it appears to be in, but rather just closer to the corner.
クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります。
ガイド手順編集のキーボードショートカット:
Ctrl + Shift + N
下に新しい行を挿入
Ctrl + Shift + P
上に新しい行を挿入
すべてのショートカットを表示する