メインコンテンツにスキップ

修理を始めるには

修理する権利

ストア

ご注意:あなたは前提となるガイドを編集しています。あなたが行なう変更は、この手順を含むガイド全体に反映されます。

英語
日本語

手順 1を翻訳中

手順1
Using your tweezers, undo all ribbon cable you see where the keyboard was removed. Remove all 9mm screws from the rear panel of your computer. They are marked red in the first picture. Remove all 5mm screws from the rear panel of your computer. They are marked orange in the first picture.
  • Using your tweezers, undo all ribbon cable you see where the keyboard was removed.

  • Remove all 9mm screws from the rear panel of your computer. They are marked red in the first picture.

  • Remove all 5mm screws from the rear panel of your computer. They are marked orange in the first picture.

  • Using your fingers, push the bottom of the battery compartment out slightly, making a small gab in the face plate on the opposite side.

  • Using the spudger, undo all clips around the outer edge of the computer, popping the front face plate out of the enclosure. If you meet resistance, you most likely forgot to remove a screw, check for any that are still there, and remove them.

  • Once the front plate has been popped out, look close to make sure all connections are disconnected from it before pulling it away from the computer.

ここに翻訳を挿入する

ここに翻訳を挿入する

ここに翻訳を挿入する

ここに翻訳を挿入する

ここに翻訳を挿入する

ここに翻訳を挿入する

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります