メインコンテンツにスキップ

修理を始めるには

修理する権利

パーツ&ツール

英語
日本語

手順 8を翻訳中

手順8
Now you can remove and manipulate the circuit board.  There is one last wire attaching it to the other board, but it is difficult and unnecessary to remove. Locate any capacitors that are blown.  The tops will be rounded rather than flat or could have dried orange fluid spilling from the tops.  These need to be replaced.  Identify their capacitance and voltage and remember these. Using a soldering iron and desoldering tape, remove the solder attaching any blown capacitors.
Removing the capacitors
  • Now you can remove and manipulate the circuit board. There is one last wire attaching it to the other board, but it is difficult and unnecessary to remove.

  • Locate any capacitors that are blown. The tops will be rounded rather than flat or could have dried orange fluid spilling from the tops. These need to be replaced. Identify their capacitance and voltage and remember these.

  • Using a soldering iron and desoldering tape, remove the solder attaching any blown capacitors.

ここに翻訳を挿入する

ここに翻訳を挿入する

ここに翻訳を挿入する

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります