メインコンテンツにスキップ

修理を始めるには

修理する権利

パーツ&ツール

英語
日本語

手順 14を翻訳中

手順14
Bend the leads of the small red diode and insert them into the terminal marked D1. Make sure that the cathode (marked by a small black band) lines up with the white stripe to the left of where it says D1 on the circuit board. Use the same method you used to solder the resistors to the board to install the diode.
  • Bend the leads of the small red diode and insert them into the terminal marked D1.

  • Make sure that the cathode (marked by a small black band) lines up with the white stripe to the left of where it says D1 on the circuit board.

  • Use the same method you used to solder the resistors to the board to install the diode.

ここに翻訳を挿入する

ここに翻訳を挿入する

ここに翻訳を挿入する

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります