Skip to main content
英語
日本語

手順 1を翻訳中

手順1
Remove the white tape from either end of the rear of the CCFL assembly. Carefully remove about 15-20mm of heat shrink from the CCFL cable to allow the end cap to be removed, making sure you DO NOT cut or nick the wire insulation. The wires have a HIGH VOLTAGE applied during operation and the insulation may break down if damaged causing a short
  • Remove the white tape from either end of the rear of the CCFL assembly.

  • Carefully remove about 15-20mm of heat shrink from the CCFL cable to allow the end cap to be removed, making sure you DO NOT cut or nick the wire insulation.

  • The wires have a HIGH VOLTAGE applied during operation and the insulation may break down if damaged causing a short

  • While holding the assembly, slowly and gently pull the THICK wires up and out of the slots in the white rubber cap.

  • Pull the wires one at a time ensuring you don't flex the CCFL and break it.

  • This will reveal the pins and solder joints.

ここに翻訳を挿入する

ここに翻訳を挿入する

ここに翻訳を挿入する

ここに翻訳を挿入する

ここに翻訳を挿入する

ここに翻訳を挿入する

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります