Skip to main content

注意:あなたはさきほど閲覧しているガイドの前提となるページを編集しています。あなたが行った変更は、この手順を含むガイド全体に影響を与えます。

英語
日本語

手順 3を翻訳中

手順3
After removing the rubber stoppers on top, there should be six exposed screws. Remove these using the T6 screwdriver. Next, use the spudger to loosen the case underneath the shiny metal edge. Go all the way around the phone until completely loosened. The case is superglued on and will not permanently damage the phone when removed, but you should still use caution.
  • After removing the rubber stoppers on top, there should be six exposed screws. Remove these using the T6 screwdriver.

  • Next, use the spudger to loosen the case underneath the shiny metal edge. Go all the way around the phone until completely loosened.

  • The case is superglued on and will not permanently damage the phone when removed, but you should still use caution.

  • After loosening the case, remove it.

  • There is a wire that connects both the top and bottom of the case. If you are not careful when removing the case, you might snap the wire.

ここに翻訳を挿入する

ここに翻訳を挿入する

ここに翻訳を挿入する

ここに翻訳を挿入する

ここに翻訳を挿入する

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります