注意:あなたは必要条件ガイドを編集しています。あなたが行なう変更は、この手順を含む全ての5個のガイドに反映されます。
-
Ribbon cable "3" is held in place by a FPC style connector. You must unlock this connector before sliding the ribbon cable out. The locking mechanism is on the opposite side of where the cable is inserted - it swivels upwards 90 degrees. Use a plastic spudger to lift the locking mechanism.
-
The FPC locking latch is very delicate and is typically a different color than the body of the connector. (see the detail image of FPC connector open and closed)
-
Slide the ribbon cable out of the connector, and remove the display assembly from the iPhone.
-
It's impossible to properly reinsert a ribbon into an FPC connector unless the lock is disengaged. Make sure the locking latch is open when attaching/detaching the cable.
クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります。
ガイド手順編集のキーボードショートカット:
Ctrl + Shift + N
下に新しい行を挿入
Ctrl + Shift + P
上に新しい行を挿入
すべてのショートカットを表示する