Skip to main content

注意:あなたはさきほど閲覧しているガイドの前提となるページを編集しています。あなたが行った変更は、この手順を含むガイド全体に影響を与えます。

英語
日本語

手順 5を翻訳中

手順5
Make sure the battery is disconnected before you disconnect or reconnect the cable in this step. Disconnect the display cable by prying it straight up from its socket on the logic board.
  • Make sure the battery is disconnected before you disconnect or reconnect the cable in this step.

  • Disconnect the display cable by prying it straight up from its socket on the logic board.

スパッジャーの平面側先端や指の爪先を使って、基板上ソケットからディスプレイデータケーブルをまっすぐ上に引き上げて外します。

[* black] Useicon_caution] Make sure the flat end of a spudger, or a fingernail, tobattery is disconnected before you disconnect or reconnect the cable in this step.
[* black] Disconnect
the display data cable by prying it straight up from its socket on the logic board.
[* black] Useicon_caution] Make sure the flat end of a spudger, or a fingernail, tobattery is disconnected before you disconnect or reconnect the cable in this step.
[* black] Disconnect
the display data cable by prying it straight up from its socket on the logic board.

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります