メインコンテンツにスキップ
英語
日本語

手順 6を翻訳中

手順6
There are four stripping holes of varying sizes on the wire stripper. Carefully position the cable in the largest (innermost) hole on the wire stripper and line up the edge of the jaws with the mark you just made as seen in the first picture. Squeeze the wire stripper to remove the outer cord tubing, revealing wire strands beneath.
  • There are four stripping holes of varying sizes on the wire stripper.

  • Carefully position the cable in the largest (innermost) hole on the wire stripper and line up the edge of the jaws with the mark you just made as seen in the first picture.

  • Squeeze the wire stripper to remove the outer cord tubing, revealing wire strands beneath.

  • If necessary, slide the outer sheath off the end of the cable.

ここに翻訳を挿入する

ここに翻訳を挿入する

ここに翻訳を挿入する

ここに翻訳を挿入する

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります