メインコンテンツにスキップ
英語
日本語

手順 8を翻訳中

手順8
Remove the three T9 torx screws then the two phillips PH 0 long screws. Pull up on the left side (the side without the four wires), then on the right side. The right side of the power supply will be harder to pull up on so you'll need to pull firmly. After you get it loose you'll be able to pull it up a bit but it will still be connected by the four wire connector so don't pull it all the way out until that has been disconnected (shown in the next step).
Remove the Power Supply
  • Remove the three T9 torx screws then the two phillips PH 0 long screws.

  • Pull up on the left side (the side without the four wires), then on the right side. The right side of the power supply will be harder to pull up on so you'll need to pull firmly.

  • After you get it loose you'll be able to pull it up a bit but it will still be connected by the four wire connector so don't pull it all the way out until that has been disconnected (shown in the next step).

T9トルクスねじ3本を、次にPH 0長軸プラスねじ2本を取り外します。

左側(4本のワイヤがない側)を引き上げ、次に右側を引き上げます。電源の右側は引き上げにくいため、強く引っ張る必要があります。

電源が緩んだら、少しだけ上に引き上げられるようになりますが、まだ4芯ワイヤコネクタで接続されているため、これらを取り外す(次の手順を参照)までは一気に引き抜かないでください。

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります