メインコンテンツにスキップ

注意:あなたは必要条件ガイドを編集しています。あなたが行なう変更は、この手順を含む全ての38個のガイドに反映されます。

英語
イタリア語

手順 2を翻訳中

手順2
Take extra caution with these screws as they can strip easily!
  • Take extra caution with these screws as they can strip easily!

  • Remove the following 3 screws from the rear wall of the battery compartment:

  • One 3 mm Phillips #0. (Head: 2.75 mm. dia.)

  • Two 4 mm Phillips #0 on the either side. (Head: 2.75mm dia.)

Rimuovere le 3 viti seguenti dalla parete posteriore dello scomparto della batteria:

Una vite con testa a croce Phillips #0 da 3 mm. (Testa: 2,75 mm di diametro)

Quattro viti con testa a croce Phillips #0 da 4 mm su entrambi i lati. (Testa: 2,75 mm di diametro)

Presta particolare attenzione a queste viti, si possono spanare facilmente.

[* icon_caution] Take extra caution with these screws as they can strip easily!
[* black] Remove the following 3 screws from the rear wall of the battery compartment:
[* red] One 3 mm Phillips #0. (Head: 2.75 mm. dia.)
[* orange] Two 4 mm Phillips #0 on the either side. (Head: 2.75mm dia.)
[* icon_caution] Take extra caution with these screws as they can strip easily.

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります