メインコンテンツにスキップ

注意:あなたはさきほど閲覧しているガイドの前提となるページを編集しています。あなたが行った変更は、この手順を含むガイド全体に影響を与えます。

英語
日本語

手順 1を翻訳中

手順1
Remove two Phillips screws securing the battery connector bracket to the logic board, of the following lengths:
  • Remove two Phillips screws securing the battery connector bracket to the logic board, of the following lengths:

  • One 2.9 mm screw

  • One 2.3 mm screw

  • Throughout this guide, keep careful track of your screws so that each one goes back where it came from during reassembly. Installing a screw in the wrong place can cause permanent damage.

基板に留められたバッテリーコネクターブラケットから、次のプラスネジを取り外します。

2.9 mmネジー1本

2.3 mmネジー1本

[* black] Remove the following Phillipstwo Phillips screws securing the battery connector bracket to the logic boardboard, of the following lengths:
[* black] Remove the following Phillipstwo Phillips screws securing the battery connector bracket to the logic boardboard, of the following lengths:
[* red] One 2.9 mm screw
[* orange] One 2.3 mm screw
[* icon_reminder] Throughout this guide, [product|IF145-167-4|keep careful track of your screws|new_window=true] so that each one goes back where it came from during reassembly. Installing a screw in the wrong place can cause permanent damage.

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります