メインコンテンツにスキップ
英語
日本語

手順 19を翻訳中

手順19
Once all solder is removed, pry the dock connector straight down from the logic board using a metal spudger. DO NOT remove the dock connector before all solder is removed, as the pins will rip from the dock connector and get stuck in the logic board.
  • Once all solder is removed, pry the dock connector straight down from the logic board using a metal spudger.

  • DO NOT remove the dock connector before all solder is removed, as the pins will rip from the dock connector and get stuck in the logic board.

  • If done properly, you should be able to see straight through the logic board where all 30 pins and the two metal joints used to be.

ここに翻訳を挿入する

ここに翻訳を挿入する

ここに翻訳を挿入する

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります