メインコンテンツにスキップ
英語
日本語

手順 6を翻訳中

手順6
Once the plastic housing is separated, disconnect the ribbon wire located on the back of the LCD display. This can be achieved by pulling up lightly on the  brown  bar that locks the ribbon wire to the circuit board.. Disconnect the remaining two ribbon wires the same way. They are located on the right rear side of the LCD frame. Disconnect the remaining two ribbon wires the same way. They are located on the right rear side of the LCD frame.
  • Once the plastic housing is separated, disconnect the ribbon wire located on the back of the LCD display. This can be achieved by pulling up lightly on the brown bar that locks the ribbon wire to the circuit board..

  • Disconnect the remaining two ribbon wires the same way. They are located on the right rear side of the LCD frame.

ここに翻訳を挿入する

ここに翻訳を挿入する

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります