注意:あなたは必要条件ガイドを編集しています。あなたが行なう変更は、この手順を含む全ての2個のガイドに反映されます。
手順 12を翻訳中
手順12


-
If using liquid adhesive remover, apply a few more drops under each of the final two, middle cells.
-
Allow 2-3 minutes for the adhesive remover to penetrate before you continue.
-
Gently folding the right-most battery cells out of the way, insert a plastic card under the right center cell.
-
Push the card in about half of its length to cut the adhesive holding the battery cell to the case.
-
Leave the card in place to keep the adhesive from re-sealing.
クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります。