メインコンテンツにスキップ

修理を始めるには

修理する権利

ストア

注意:あなたは必要条件ガイドを編集しています。あなたが行なう変更は、この手順を含む全ての6個のガイドに反映されます。

英語
ドイツ語

手順 1を翻訳中

手順1
Remove any kapton tape over the screws, if necessary.
  • Remove any kapton tape over the screws, if necessary.

  • Remove the following 3 screws:

  • Two 3 mm Phillips screws near the dock connector.

  • One 4 mm Phillips screw along the edge of the logic board.

  • During reassembly, make sure to put back any tape or plastic you remove. This will prevent any shorts between the logic board and the rear panel. If your tape is unusable, kapton tape can be purchased online.

Falls nötig, entferne jegliches Kapton Klebeband über den Schrauben.

Entferne die folgenden 3 Schrauben

Zwei 3mm Kreuzschlitzschrauben neben dem Dock-Connector.

Eine 4 mm Kreuzschlitzschraube entlang der Kante des Logic Boards.

[* icon_note] Remove any kapton tape over the screws, if necessary.
[* black] Remove the following 3 screws:
[* red] Two 3 mm Phillips screws near the dock connector.
[* orange] One 4 mm Phillips screw along the edge of the logic board.
[* icon_caution] During reassembly, make sure to put back any tape or plastic you remove. This will prevent any shorts between the logic board and the rear panel. If your tape is unusable, kapton tape can be purchased online.

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります