メインコンテンツにスキップ
英語
日本語

手順 2を翻訳中

手順2
Two screws hold the power connector in place. Remove these before trying to remove anything else.
Inside the Tablet
  • Two screws hold the power connector in place. Remove these before trying to remove anything else.

  • Four screws and one cable will remove the speaker assembly.

  • Three screws and a pop on connector secure the micro-SD reader.

  • There are several screws that hold the battery tray in place. The battery is held in with fairly strong adhesive, so I didn't try to take it out of the tray.

  • Three cables are attached to the touch board. I didn't try to remove this board from the frame.

  • Disconnect the four cable connectors that lay across the battery. The cables with blue tabs do not have a locking mechanism holding the cable in place.

  • There are two magnets located at the bottom center. More than likely used for a case cover or for a feature not included on this tablet.

ここに翻訳を挿入する

ここに翻訳を挿入する

ここに翻訳を挿入する

ここに翻訳を挿入する

ここに翻訳を挿入する

ここに翻訳を挿入する

ここに翻訳を挿入する

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります