メインコンテンツにスキップ
英語
日本語

手順 6を翻訳中

手順6
Remove 2 Screws from either side of the click wheel on the lower tier of the PCB. Remove the 3 screws from the top tier of the PCB. Do not separate the PCB from the plastic backing too fast.  There is a separate small PCB screwed into the plastic backing which is connected to the main PCB with 2 wires.
Separate PCB from bottom plastic guard
  • Remove 2 Screws from either side of the click wheel on the lower tier of the PCB.

  • Remove the 3 screws from the top tier of the PCB.

  • Do not separate the PCB from the plastic backing too fast. There is a separate small PCB screwed into the plastic backing which is connected to the main PCB with 2 wires.

  • Remove the screw holding the small PCB to the plastic backing

ここに翻訳を挿入する

ここに翻訳を挿入する

ここに翻訳を挿入する

ここに翻訳を挿入する

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります