注意:あなたは必要条件ガイドを編集しています。あなたが行なう変更は、この手順を含む全ての11個のガイドに反映されます。
-
Remove the 4.8 mm standoff screw near the headphone jack.
-
Standoff screws are best removed using a standoff screwdriver or bit.
-
In a pinch, a small flathead screwdriver will do the job—but use extra caution to ensure it doesn't slip and damage surrounding components.
-
When reassembling the device, this standoff sets the height of the Wi-Fi shield removed in step 13. If not torqued down, the shield will be above the plane of the frame and the back will not slide into place in step 2. The shield should be flush with the headphone jack.
-
When reassembling the motherboard, ensure that its edge sits under the circled standoff, otherwise the screws will not fit.
-
When reassembling ensure that the small rubber spacer attached to the top of the motherboard is in place.
-
Without this part, the motherboard could damage the ribbon cables around it.
クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります。
ガイド手順編集のキーボードショートカット:
Ctrl + Shift + N
下に新しい行を挿入
Ctrl + Shift + P
上に新しい行を挿入
すべてのショートカットを表示する