手順番号19–iPad 2 GSM Volume and Power Button Cable Replacementを翻訳 - iFixit

修理を始めるには

修理する権利

ストア

注意:あなたはさきほど閲覧していたガイドの前提条件を編集しています。あなたが行った変更は、この手順を含む個のガイド全体に影響を与えます。

ガイドに戻る

英語

日本語

前の手順次の手順

手順 19を翻訳中

手順19

To remove the upper component board you will be pulling gently on its cable while lifting it up enough to clear the battery, but not high enough to scrape against the rear case. Go slowly and carefully.

Insert the tip of a spudger under the upper component board to lift it slightly.

Pull the board up and out of the space between the battery and the rear case bezel.

To remove the upper component board you will be pulling gently on its cable while lifting it up enough to clear the battery, but not high enough to scrape against the rear case. Go slowly and carefully.
Insert the tip of a spudger under the upper component board to lift it slightly.
Pull the board up and out of the space between the battery and the rear case bezel.
Remove the upper component board.
On reassembly, you'll want to reconnect the GPS antenna cable at this point. Use tweezers and work carefully.

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります。