メインコンテンツにスキップ

ご注意:あなたは前提となるガイドを編集しています。あなたが行なう変更は、この手順を含むガイド全体に反映されます。

英語
ドイツ語

手順 3を翻訳中

手順3
Remove the two 4.0 mm T5 Torx screws securing the MagSafe DC-In board to the upper case. Depending on your model, the DC-In  board may not be secured to the upper case.
  • Remove the two 4.0 mm T5 Torx screws securing the MagSafe DC-In board to the upper case.

  • Depending on your model, the DC-In board may not be secured to the upper case.

  • Slide the MagSafe DC-In board towards the right to free it from its recess within the upper case.

  • Lift and remove the MagSafe DC-In board out of the upper case assembly.

Entferne die beiden 4.0mm T4 Torx Schrauben, die die Stromeingangsplatine befestigen.

Ziehe die Stromeingangsplatine nach rechts um sie aus der Einbuchtung im Gehäuse zu ziehen.

Hebe die Stromeingangsplatine an und entferne sie aus dem Gehäuse.

[* red] Remove the two 4.0 mm T5 Torx screws securing the MagSafe DC-In board to the upper case.
+ [* icon_note] Depending on your model, the DC-In board may not be secured to the upper case.
[* black] Slide the MagSafe DC-In board towards the right to free it from its recess within the upper case.
[* black] Lift and remove the MagSafe DC-In board out of the upper case assembly.

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります