メインコンテンツにスキップ

注意:あなたは必要条件ガイドを編集しています。あなたが行なう変更は、この手順を含む全ての8個のガイドに反映されます。

英語
イタリア語

手順 27を翻訳中

手順27
The Lightning connector cable is stuck to the case with some adhesive. To detach the adhesive you will be sliding an opening pick between the cable and the case. Be very careful not to cut the Lightning connector cable itself. Insert an opening pick under the Lightning cable where it meets the logic board. Slide the pick down and around the bend in the cable.
  • The Lightning connector cable is stuck to the case with some adhesive. To detach the adhesive you will be sliding an opening pick between the cable and the case. Be very careful not to cut the Lightning connector cable itself.

  • Insert an opening pick under the Lightning cable where it meets the logic board.

  • Slide the pick down and around the bend in the cable.

Il connettore del cavo Lightning è bloccato sul case tramite un po' di adesivo. Per staccare l'adesivo dovrai far scorrere uno strumento di apertura tra il cavo e il case. Stai molto attento a non tagliare il cavo stesso di collegamento della porta Lightning.

Inserisci un plettro di apertura sotto il cavo della porta Lightning dove incontra la scheda logica.

Fai scorrere il plettro di apertura intorno alla piega del cavo.

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります